13" or 25" Metal Shear

Model 3001 Standard Features:

“Flip-Up Hold-Down”
Accucutter®’s exclusive “Flip-Up Hold-Down” is standard on all standard 3001 shears. When in the down position, it automatically applies pressure to the material to facilitate smooth, accurate cutting. When necessary, the hold-down may be flipped up out of the way to permit easy access to the blades.

Reversible Action
Most people working with smaller shears prefer a guillotine shear that cuts from the “left to right“ while most people working with larger shears are accustomed to a guillotine shear that cuts from “right to left”. To accommodate both, the 3001 may be set up to cut in either direction. The direction of the action is set at the time of initial assembly and may be changed at any time by following the instructions in the Operator’s Manual. The reversible action feature is unique to Accucutter®’s 3001 and only applies to the 13" models.

Movable Handle
The shear handle may be installed on the left or right of the shear enabling right handed and left handed operators to use the same shear. The handle may be moved easily and independently of the shear cutting action discussed above.

Reversible Precision Drop-Off Bar
The Precision Drop-Off Bar is full width (12" or 24") and is an invaluable aid for making accurate, repetitive cuts. It has two mounting positions. It may be mounted to the top blade carrier. In this position it moves up and down with the top blade like the rear gauge on many larger guillotine shears. In upper position the rear gauge is above the material and doesn't interfere with the material as it falls away from the shear after it is cut. It also may be mounted to the bottom blade carrier in a fixed position like the rear gauge for most scissors type shears. In this position, it does not move with the upper shear blade, but can interfere with the material clearing the machine after it is cut. It slides on two alignment rods and is locked in position by turning a knob on each rod. This feature is only available on the 13" model.

Step Ruler
The typical ruler is a stamped piece of thin metal. The ruler from Accucutter® is machined from a thick, solid piece of steel. There are six separate steps involved in its manufacture with the last being a precision grinding of the front edge to insure that the ruler is straight and true. Because of its thickness, it is very stable, and the edge will not lift or distort allowing material to slide underneath the ruler. Lastly, the ruler is stepped to place the measuring edge close to the work surface for easier reading. The ruler is graduated in 1/16th's of an inch.

Blade Adjustment
The standard 3001 uses the same blade system pioneered by Accucutter® on its 2001 Bench Shear. The blades are mounted with tapped bolts rather than the old fashion nut and bolt system, and the bottom blade is adjusted with set screws instead of eccentrics. A much safer, quicker and simpler method of installing and adjusting the blades.

Shear Capacity:
· Aluminum................................................. .040"
· Brass....................................................... .025"
· Flexible Plastic......................................... .125"
· Brass Plated Steel.................................... .025"

Size & Weight:
· 3001/13 - 26"L x 20"W x 12.5"H (W/out handle); Approximately 85 lbs.
· 3001/25 - 26"L x 32"W x 12.5"H (W/out handle); Approximately 150 lbs.