Cornermate Cutting System

The Cornermate® Series is the new standard for cutting corners, holes and slots in plaques, badges, signs, and other items. There are over thirty interchangeable cutting units from 1/8” to 1”. All units are precision engineered and manufactured from the finest materials and will produce flat, crisp shapes in photographic paper, laminations, magnetics, flexible plastic, aluminum, brass, and many other materials. Each cutting unit has the material guides machined into the body of the unit so the location of the cut is always the same.

The picture at the top left shows the basic table, the CM40A, with a cutting unit. The picture to the right shows the CM40A from the rear without a cutting unit. From the rear view the new handle/post assembly can be seen clearly. The end of the handle is now solid and the pivot passes through the solid part of the handle. This setup is stronger than the previous one. Previously the end of the handle was cut out and the post inserted in the cutout. Only Accucutter® uses the new, stronger setup.

To use, the cutting unit is placed in a machined recess in the table, the material is inserted into the cutting unit, and the handle is squeezed. It is that simple and that quick!

For heavier materials use the Cornermate PLUS.

A New Manual Cornermate Table:

In response to requests for a manual table that is easier to use, a new Cornermate table has been developed that requires approximately one half of the effort of the standard table. The difference is noticeable with all materials, but it is very obvious when punching holes and slots in brass and brass plated steel.

The new table is called the CM40 Special (CM40SPCL), and it is available immediately. It has the standard adapter that permits the use of all of the original cutting units from 1/8" to 1".

The original Cornermate table, the CM40A, is still available.

Available Cutting Units:

     · Round - 1/8", 3/16", 1/4" 5/16", 3/8", 1/2", 3/4", 1"
     · Notch - 1/8", 3/16", 1/4", 3/8", 1/2", 3/4", 1"
     · Scallop - 1/4", 3/8", 1/2"
     · Hole Punch - 3/32", 1/8", 3/16"
     · Slot - 1/8" x 9/16"
     · Chamfer - 1/4", 3/8"

Cornermate Capacity:
     · Aluminum.................................................. .040"
     · Half Hard Brass.......................................... .025"
     · Flexible Plastic.......................................... .125"
     · Brass Plated Steel..................................... .015"

Size & Weight:
     · CM40A - 10"L x 6.5"W x 6"H; Approximately 6 lbs. (With cutting unit.)
     · CM40SPCL - 10"L x 6.5"W x 8.5"H; Approximately 6.5 lbs. (With cutting unit.)

Availability & Ordering
     The manual Cornermates are available for immediate shipping.